Digital Burner Controller DBC2000E1018 Honeywell Vietnam

Mô tả
Đánh giá (0)

Digital Burner Controller DBC2000E1018 Honeywell Vietnam

100% USA/China
Origin

Honeywell
Vietnam

Correct Model: DBC2000E1018
Digital Burner Controller
(BC2000E1018 200V, 50/60Hz Tp = 35s, Ts 1/2 = 5/3s, FFRT<(><<)>1s)
Note : recheck CODE + STOCK khi order

The Honeywell DBC2000 is a microprocessor-based integrated burner controller for automatically fired gas, oil or combination fuel industrial single burner power burner applications. The DBC2000 system consists of the relay module and wiring subbase.
The DBC2000 Standard Model provides the minimum requirements to control an industrial burner system, such as automatic burner sequencing, flame supervision, system status indication, system or self-diagnostics and troubleshooting. The DBC2000 Enhanced Model includes an integrated Valve Proofing System, whilst the Ultimate model includes bus communication on top of this.

The DBC2000 is programmed to provide a level of safety, functional capability and features beyond the capacity of conventional controls.

FEATURES
• Employs a plug-in mounting method
• Uses a microprocessor to improve performance
• Status and fault indication by indicator LEDs
• A 4-wire firing rate switching circuit controls an air damper motor or other auxiliary equipment during start-up of the burner.
• Safe start check before and during pre-purge
• Dual flame amplifier for UV, IR or flame rod sensor
• Automatic recycle once per 24h of uninterrupted heat demand.
• Frontal jack plug (Ø 3.5mm) to read the flame signal with a microampere meter.
• An electrical sub base lock (reset and safety limit terminals are swapped) to avoid that a Standard model is used systems wired for an Enhanced or Ultimate model. The DBC2000 cannot start then.